“steering pump”造句，怎麼用steering pump造句

Pump maintenance should check the steering pump belt tightness, to see if there are fracture, if the replacement should be timely, tightness in the fingers should be about 1cm better press;

Using the utility model of relieving attachment could remove the steel cable baffle ring very conveniently and avoid prizing and breaking the steering pump on removing the steel cable baffle ring.

If equipped, attach the power steering pump and bracket.

When steering pump pressure exceeds 3275 kPa ± 690 kPa (475 psi ± 1psi), the normally closed switch circuit will open and the PCM will increase the engine idle spee

The reasons for the failure of oil increasing in the gearbox of ZL50 load-hauler-dumper are the seal of work pump and steering pump out of work or already spoiling.

Rust particles could then enter the power steering pump and cause it to shut down to avoid overheating.

Loosen the accessory drive belt at the power steering pump bracket, if equipped or at the idler pulley bracket (refer to Group 7, Cooling System for the proper procedure).

Loosen the accessory drive belt tension and remove the belt from the power steering pump (refer to Group 07, Cooling Systems for proper procedures).