“interference fit”造句，怎麼用interference fit造句

It presents the principle and the construction of hydraulic mounting and dismounting, and the calculation of hydraulic interference fit.

Three quenched bushes are pressed on the hollow spindle (sleeve) with a big interference fit, thus the spindle can move forward and backward precisely within the bush.

Cylindrical bore bearing is usually installed with heat, reduce the use of interference fit bearing clearance, or achieving the purpose of pretension.

Spindle is a key unit of the high-speed machine tool, while the interference fit between spindle and motor rotor is one of the most important factors influencing the performance of the spindle unit.

FEM stress analysis of assemble symmetrical body of interference fit.

High precision simulative analysis on conical interference fit of bearing inner ring of precision grinding machine

In this paper, the design medthod of interference fit of rolling bush has been discussed, and a calculating method is put forward to work out the interference when measuring the circumference.

A tendon or ligament also can be secured to bone through a drill hole using a screw for an interference fit as in anterior cruciate ligament reconstruction procedures( see Chapter43).

The washer shall be clinched to the stud end with a tight slip fit to an interference fit.

"The rotor shall have an interference fit to the shaft and the rotating assembly shall be dynamically balanced to ISO 1940, G.6.3."

An experimental study was conducted to measure residual stress distribution around cold-expanded fastener holes and interference stress distribution near interference fit fastener holes.

Tolerances and fits--The calculation and selection of interference fits