“crankshaft”造句，怎麼用crankshaft造句

Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.

It is interlocked with the crankshaft via the chain drive.

Position drive plate on the crankshaft's dowel pin and press on to the crankshaft flange.

The power mechanism of engine is actually called the crankshaft and connecting rod mechanism.

Based on the analysis of plastic flow law in crankshaft forming, the cause of typical forming defects, i. e. the folding existing in the crankshaft pin and crank arm was found out.

Semifinished main bearings require finishing and fitting after installation, so that the crankshaft must be taken out.

A new structure for fixing the bearing bush of the connecting lever in a crankshaft press is introduced.

The reason why crankshaft must be equipped the equivalent ring at the crankpin when the dynamical equilibrium test is made is pointed out.

This variety of options provides flexibility for achieving solutions for a wide range of applications, including automotive transmission and crankshaft speed sensing.

The concept of reliability of function for crankshaft-connecting rod system is discussed, and the wear-out factors which make system function lost are analysed.

The rod journals are bored hollow in order to reduce the crankshaft inertia. Drilled diagonally through the crank arms are oil holes to supply oil to the rod journals.

"Where the entire cycle of events in the cylinder requires four strokes (or two crankshaft revolutions), the engine is called a four-stroke-cycle engine, or a four-cycle engine. The four piston strokes are intake, compression, power and exhaust."

Remove front crankshaft belt pulley.

Install new front crankshaft oil seal.

Widely used in gasoline engine crankshaft, diesel engine crankshaft, transmission, differentials, shock absorbers, engines, axles and other parts.

The flywheel mounts to the engine's crankshaft and transmits engine torque to the clutch assembly .

Using furan sand to produce heavy diesel engine block and crankshaft eliminated defects of castings including “penetration/burn-in”,“shrinkage porosity”,“big dimension deviation” of cylinder block,“penetration/bum-in”,“misrun”and“run-out”of crankshaft,and so on.

Two kinds of inspection methods of the position error of key slot an gear journal of crankshaft have been proposed.

In Lanchester's design, two balance shafts rotated in opposite directions at twice the crankshaft speed to cancel out the niggling secondary vibrations.

The crankshaft revolves in bearings located in the engine crankcase, but the number of bearings used usually depends on the number of cylinders in the engine, and the design of the engine.

Remove chain drive wheel from crankshaft.

The metal case enclosing the crankshaft and associated parts in a reciprocating engine.

The nitrite chrome-molybdenum steel crankshaft guarantees the best tensile strength and surface hardness for long-time operation.

"In a two-stroke cycle, the compression and power strokes of the four-stroke cycle are carried out without the inlet and exhaust strokes, in one upstroke and one downstroke of the piston and one revolution of the crankshaft."

Similarly, in the crankshaft journal and crankshaft bearing clearance measurements, they can draw on such skills.

Because the crankshaft is built up inside the case, the bases of the rods do not need to be split and bolted back together.

The mechanism consists of several parts like the crankcase, cylinder block, pistons, connecting rod, crankshaft, etc.

The invention relates to a sectional flywheel with a plastic fan blade for an engine, which is fixed on the front end of an engine crankshaft by a flywheel nut.