“meshing”造句，怎麼用meshing造句

Analysis of Electromagnetic Problems in Complicated Cavities by FEM Based on Auto-meshing Technique;

A mathematical model of spiral bevel gear tooth surface was built by analyzing manufacture method and meshing theory.

A-operator method (AOM) is used to study the influence of the speed ratio and time varying meshing stiffness on rattling threshold speed of the gear system.

According to the theory of gearing, equation of the meshing line can be deduced from the tooth profile of basic rack.

Considering the basic ideas of boundary element method（ BEM）, we devide the boundary curve into many units and nodes, analyse the nodes meshing and wear process of these nodes, utilize parametric cubic spline curve to simulate the worn flank of tooth, so as to analyse gear meshing and wear.

The invention has beneficial effect that meshing diameter and tooth number of the driving gear and the driven gear are the same, thus, ensuring that all the shafts have same main drive speed.

Based on meshing theory, a formula is derived for calculating index error of worm-type CAM follower (i. e. Tindex plate) under influence of actual worm-type CAM profile and dimensions.

The meshing equation and the formula of meshing efficiency are drawn by using active coordinate and rotating matrix operators.

A new rolling type of spherical enveloping worm gearing with point meshing is proposed.

Because when the frequency of close to the meshing of gears susceptible to the natural resonance frequency.

This paper introduces three models the "Bottle Gourd" model, the "Twin tower" model and the "meshing" model, aiming to enhance the effect of ideological and political education.

For the two surfaces both with embossment, the effect of pressure impact is slowed down during the meshing process, while the driving wheel is mainly affected by the wear rather than passive one.

Taking the engagement theory as the starting point and considering the deviation of base pitch of gear this paper presented a concept of engagement shock at the under cut tip point and deduced the calculation formulas of impact velocity at the under cut point for meshing in and out.

An investigation on the meshing characteristics of face gear drives is made in this paper.

In this article the bearing ability test of hard gear face point-line meshing gear transmission and the trial of noise test are introduced.

These formulae are suitable for any contacting point of tooth surface meshing.

This paper presents a method of providing a virtual support for the rotor to assure the meshing stability of a pair of a pre determined spiral bevel gears in rotation.

The special meshing of convex and concave teeth profile makes the relative radius of curvature of the contacting point longer.