“gasket”造句，怎麼用gasket造句

The clapboard is sealed by "U" sealed gasket.

Improved gasket design allows sealing at lower clamping pressures.

After testing several alternative gaskets, we selected the best performing gasket in our tests - a corrugated steel gasket with graphite filled channels.

The urethane liner extends over the flange face to serve as the valve's flange gasket.

A gasketed connection has four parts: the valve outlet, a nipple, a nut, and a gasket (or washer).

A shielding gasket is disposed around the shielding shell and has overlapping rows of beams extending therefrom.

When the gasket is placed on the block and the head installed, tightening of the head bolts squeezes the soft metal so that the joint is effectively sealed.

When the chical process pump transmission medium, the tperature and pressure is not high, the general choice of non-metallic gasket;

The pressure cooker with the double leak-prevention seal ring is characterized in that the metal rim (5) is mounted in the center of the rubber gasket(4).

This paper is based on the sealing reliability of flange for the DSHE and submits a predicting calculation' s method of the bolt for seating gasket used in circular-shaped cover of the DSHE.

The article based on fabrication process of the pre-heater which is the equipment of hydrogen manufacturing unit, and the forming of Cr-Mo steel coil and welding gasket was analyzed.

The gasket cannot be reused after removal.

A spring gasket is also arranged between the flat gasket and the nut.

Flange form different requirements, the use of gasket are different.

Slide the one-piece gasket over the dowels and onto the block.

Are products are: water polo foot o ring gasket seals sucker Washers silicone chip nail head gasket sets of plastic earplugs dust jacket sets of rings, such as sealing ring.

Soft carbon steel sealing gasket of 100 Brinnel, silver-plated for soft corrosion-resistant coating, provides large contact area for perfect sealing.

The gasket had a center cut-out and six holes along the edge. The inside edge of the cut-out, along with one of the holes, was lined with a bead of rubber.

For small male and female joints care should be taken in the use of these dimensions to insure that the inside diameter of fitting or pipe is small enough to permit sufficient bearing surface to prevent the crushing of the gasket.

This collar acts as a kind of gasket .

Remove the bezel and rubber gasket from the motor output shaft.

It also owns a rubber factory which offers car rubber strip and rubber gasket to FAW, and is engaged in the rubber research for IBM, Apple and Samsung.

The engine had blown a gasket, ie the gasket had suddenly let steam, etc escape.

If the gasket breaks down, small holes develop between the cylinder and the cylinder head, and these holes cause leaks.

This gasket ring can't be used any more.

When the pipe joint screw, should follow the principle of diagonal twist, not one by one in order to operate, do not screw the screw die, so that the correct installation of rubber gasket.