“output power”造句，怎麼用output power造句

Load matching is intended to make induction heating power to the rated output power, and improve efficiency.

The success of technical modification made a remarkable increase of boiler output power and stability.

Based on the principle of the solar chimney power plant systems, analysis on the output power and the energy conversion efficiency of the systems has been presented.

High output power of the engine caused by high load, excessive wear in the course of time will form parts.

Contour modulation is a technique in which a phase-modulated signal waveform and amplifier output impedance work together to maintain higher efficiency over a sizable output power back-off.

This machine adopts the world's advanced high-Q square vibration hair with hair vibration frequency stability, output power of high harmonic less advantages.

Furthermore, we analysis the effect of difference inner-cladding structures on the absorption efficiency of pump light, and the fiber length has a significantly impact on output power.

The ratio of effectual emitter area to base area of a FFJ is 2-3 times greater than a usual transistor and the output power-impedance product is 5-10 times greater.

Finally, it also analyzed the relationship between the input pump power and the probe optical power and its output power and output extinction ratio.

The input power of any machine is equal to the output power plus the work done to overcome the friction.

It was also found that we could enhance the LED output power by using lateral epitaxial patterned sapphire (LEPS).

MPS700 series dc voltage constant-current power supply, is designed by using linear series MOSFET control mode of the ac input dc output power.

Referring to the main picture above, the two anode connections uppermost form a 50 ohm balanced line from where the output power is extracted.

This motor cannot offer the given rated output power.

Magamp is an effective solution for improving cross regulation of multi-output power converter.

The output power is measured by horn and electric probe and the frequency is measured by a wave-guide dispersion line.

The paper discusses two operating modes of single-ended flyback switching power supply, constant output voltage mode and constant output power mode.

Single Operator Low (all Band or Single Band) : One person performs all of the operating and logging functions. QSO alerting assistance is not permitted. Total output power must not exceed 100 watts.

The effect on output power of distribution of space variation, crystal length and transmissivity has been discussed in detail.